Hi, I am trying to move one of my stages (a PI-M-531) to the Reference switch as I have done numerous times before, but it says that it is on limit switch and the following error pops up when I try to move it to Reference switch:
Error while referencing Controller reported error 216 The Controller stage has driven into a limit switch, some Controllers need CLR to resume operation
How do I resume operation on my Controller?
R
Answer by
Roland Diskayne
There is a section at developer's website where you can address you question to the corresponding specialist.
No, PIMikroMove is a program specifically designed for Windows, so it cannot be run on a MAC operating system.
Hi, I am trying to move one of my stages (a PI-M-531) to the Reference switch as I have done numerous times before, but it says that it is on limit switch and the following error pops up when I try to move it to Reference switch:
Error while referencing
Controller reported error 216
The Controller stage has driven into a limit switch, some Controllers need CLR to resume operation
How do I resume operation on my Controller?
There is a section at developer's website where you can address you question to the corresponding specialist.